Proper Contact
Washer
1996 TOYOTA T100 (RM449U)
SUSPENSION AND AXLE
If the teeth are not contacting properly, use the following chart
to select a proper washer for correction.
Washer thickness
FA2008
15.
INSTALL BEARING SPACER
(a)
Remove the companion flange, oil slinger and rear bear-
ing (See page SA−48).
(b)
Install a new bearing spacer.
(c)
Install the rear bearing and oil slinger.
Z03850
−
FRONT DIFFERENTIAL CARRIER (4WD)
Heel Contact
Select an adjusting shim that will bring the drive
pinion closer to the gear.
Toe Contact
Select an adjusting shim that will shaft the drive
pinion gear away from the ring gear.
Thickness
mm (in.)
2.27 (0.0894)
2.30 (0.0906)
2.33 (0.0917)
2.36 (0.0929)
2.39 (0.0941)
2.42 (0.0953)
2.45 (0.0965)
2.48 (0.0976)
SA−63
Face Contact
Flank Contact
R02495
Thickness
mm (in.)
2.51 (0.0988)
2.54 (0.1000)
2.57 (0.1012)
2.60 (0.1024)
2.63 (0.1035)
2.66 (0.1047)
2.69 (0.1059)
−