Toyota T100 1996 Service Manual page 1529

Front Rear
SST
SST
SST
1996 TOYOTA T100 (RM449U)
SUSPENSION AND AXLE
5. CHECK RING GEAR RUNOUT
(a) Install the differential case onto the carrier and install the
2 plate washers to fill the play in the bearing (See page
SA−57).
(b) Install 2 bearing caps (See page SA−57).
(c) Using a dial indicator, measure the runout of ring gear.
Maximum runout: 0.07 mm (0.0028 in.)
Z03851
6. INSTALL DRIVE PINION FRONT AND REAR BEARING
OUTER RACES
(a) Using SST and a press, install the front side of the outer
race.
SST
(b) Using SST and a press, install the rear side of the outer
race.
SST
W00404
7. INSTALL DRIVE PINION FRONT BEARING
(a) Install the washer on the drive pinion.
HINT:
First fit a washer with the same thickness as the washer which
was removed, then after checking the tooth contact pattern, re-
place the washer with one of a different thickness if necessary.
(b) Using SST, install the front bearing onto the drive pinion.
SST
R01197
8. TEMPORARILY ADJUST DRIVE PINION PRELOAD
(a) Install the drive pinion, rear bearing and oil slinger.
HINT:
Assemble the spacer and oil seal after adjusting the gear con-
tact pattern.
(b) Using SST, install the companion flange.
SST
(c) Coat the threads of the nut with hypoid gear oil.
SST
R11163
(d) Adjust the drive pinion preload by tightening the compan-
ion flange nut.
Using SST to hold the flange, tighten the nut.
SST
NOTICE:
As there is no spacer, tighten the nut a little at a time, being
careful not to overtighten it.
SA2347
− FRONT DIFFERENTIAL CARRIER (4WD)
09950−60020 (09951−00710),
09950−70010 (09951−07150)
09950−60020 (09951−00790),
09950−70010 (09951−07150)
09506−30012
09950−30010
09330−00021
SA−59