Toyota T100 1996 Service Manual page 1393

Shift Lock
Release Link
Sliding Rod
Shift Lock
Plate Stopper
Stopper
1996 TOYOTA T100 (RM449U)
AUTOMATIC TRANSMISSION
Q02581
Q02704
Shift Lock Plate
Q02703
Q02581
− SHIFT LOCK SYSTEM
INSTALLATION
1. TEMPORARILY INSTALL SHIFT LEVER ASSEMBLY
TO STEERING COLUMN ASSEMBLY
Install the shift lever assembly to the steering column assembly
with the 2 bolts.
2. CONNECT AND ADJUST INTER LOCK
(a) Put the control shaft in the P position.
(b) Turn the ignition key plate to the LOCK position.
(c) Slide the shift lock plate of the control shaft until it touch
the surface of the holder.
(d) Slide the sliding rod, then align the center of the shift lock
pate stopper's hole and shift lock release link's hole.
(e) Install the shift lock release link.
Torque: 4.9 N·m (50 kgf·cm, 43 in.·lbf)
(f) Tighten the screw.
Torque: 1.4 N·m (14 kgf·cm, 12 in.·lbf)
(g) Turn the ignition switch key plate in the ACC position.
(h) Set the control shaft in the D position.
(i) Measure the clearance of the stopper and shift lock plate.
Clearance: 1.0 ± 0.8 mm (0.039 ± 0.031 in.)
(j) When the control shaft is set in D position, check that the
ignition key plate does not turn to LOCK position.
(k) When the control lever is changed from the R position to
L position, check that the shift lock plate does not interfere
with stopper.
(l) Set the control shaft in the P position.
When the ignition key plate is turned from the LOCK posi-
tion to the ACC position, check that the stopper is un-
locked from the lock condition.
3. TORQUE SHIFT LEVER ASSEMBLY MOUNTING
BOLTS
Torque: 29 N·m (300 kgf·cm, 22 ft·lbf)
4. INSTALL SHIFT LEVER ASSEMBLY WITH STEERING
COLUMN ASSEMBLY (See page SR−20)
5. CHECK AND ADJUST SHIFT LEVER POSITION
(See page DI−265)
AT−25
AT029−01