Toyota T100 1996 Service Manual page 895

Engine Hanger No. 2
1996 TOYOTA T100 (RM449U)
ENGINE MECHANICAL (5VZ−FE)
(c)
(d)
P21436
26.
(a)
(b)
27.
(a)
(b)
28.
29.
Remove the 8 bolts holding the mounting bracket to the mount-
ing insulator and cross member.
P15099
30.
(a)
(b)
P21444
(c)
P21459
− ENGINE UNIT (2WD)
Remove the 3 bolts and support bracket.
Remove the 3 nuts, front exhaust pipe and 3 gaskets.
M/T:
REMOVE CLUTCH RELEASE CYLINDER
Remove the 3 bolts and disconnect the clutch line.
Remove the 2 bolts and disconnect the clutch release cyl-
inder.
A/T:
REMOVE CROSS SHAFT
Remove the clip and disconnect the shifting rod.
Remove the nut, 4 bolts and the cross shaft.
PLACE JACK UNDER TRANSMISSION
REMOVE ENGINE REAR MOUNTING BRACKET
REMOVE ENGINE WITH TRANSMISSION
w/ A/C:
Remove the bolt and disconnect the A/C compressor wire
clamp.
Install a engine hanger No.2 in the correct direction.
Part No.:
Engine hanger No.2 12282−62030
Bolt 91512−61020
Torque:40 N·m (400 kgf·cm, 30 ft·lbf)
Attach the engine hoist chain to the 2 engine hangers.
EM−67