Toyota T100 1996 Service Manual page 985

New
Grommet
Upward
Turn
1996 TOYOTA T100 (RM449U)
MFI (3RZ−FE)
INSTALLATION
1.
(a)
(b)
New
O−Ring
P14758
(c)
(d)
Push
P14756
2.
(a)
(b)
(c)
P14757
(d)
HINT:
If injectors do not rotate smoothly, the probable cause is incor-
rect installation of O−rings. Replace the O−rings.
(e)
(f)
3.
P24768
4.
5.
6.
7.
8.
− INJECTOR
INSTALL INJECTORS TO DELIVERY PIPE
Install a new grommet to the injector.
Apply a light coat of gasoline to a new O−ring and install
it to the injector.
While turning the injector left and right, install it to the de-
livery pipe. Install the 4 injectors.
Position the injector connector upward.
INSTALL INJECTORS AND DELIVERY PIPE
Place the 4 new insulators and in position on the spacers.
Place the 4 injectors together with the delivery pipe in
position on the cylinder head.
Temporarily install the 2 bolts holding the delivery pipe to
the cylinder head.
Check that the injectors rotate smoothly.
Position the injector connector upward.
Tighten the 2 bolts holding the delivery pipe to the cylinder
head.
Torque: 21 N·m (210 kgf·cm, 15 ft·lbf)
INSTALL THROTTLE BODY (See page MF−30)
REINSTALL HIGH−TENSION CORDS TO SPARK
PLUGS
INSTALL NO.1 AND NO.2 PCV HOSES
INSTALL AIR INTAKE CONNECTOR
M/T:
CONNECT ACCELERATOR CABLE TO THROTTLE
BODY
A/T:
CONNECT THROTTLE AND ACCELERATOR CABLES
TO THROTTLE BODY
MF−21
SF0AT−03