Toyota T100 1996 Service Manual page 878

EM−50
SST
Seal
Packing
1996 TOYOTA T100 (RM449U)
ENGINE MECHANICAL (5VZ−FE)
(b)
P20989
(c)
P20847
(d)
3.
(a)
(b)
P20848
4.
(a)
(b)
P12390
(c)
(d)
(e)
P20844
− CYLINDER HEAD
Install these parts:
(1) Valve
(2) Spring seat
(3) Valve spring
(4) Spring retainer
Using SST, compress the valve spring and place the 2
keepers around the valve stem.
SST 09202−70020 (09202−00010)
Using a plastic−faced hammer, lightly tap the valve stem
tip to ensure a proper fit.
INSTALL VALVE LIFTERS AND SHIMS
Install the valve lifter and shim.
Check that the valve lifter rotates smoothly by hand.
INSTALL CAMSHAFT HOUSING PLUGS
Remove any old packing (FIPG) material.
Apply seal packing to the bearing cap as shown.
Seal packing:
Part No. 08826−00080 or equivalent
Place a new housing plug in position on the cylinder head,
facing the cap side inward.
Install the camshaft bearing cap with the 2 bolts.
Torque: 16 N·m (160 kgf·cm, 12 ft·lbf)
Install the cylinder head rear plate, ground strap with the
bolt and nut.
Torque: 8 N·m (80 kgf·cm, 71 in.·lbf)