Toyota T100 1996 Service Manual page 817

EM−94
Cut Position
1996 TOYOTA T100 (RM449U)
ENGINE MECHANICAL (3RZ−FE)
SST
P14980
(b)
NOTICE:
Be careful not to damage the crankshaft.
Tape the screwdriver tip.
P14983
SST
P14966
− CYLINDER BLOCK
(2) Using SST and a hammer, tap in a new oil seal until
its surface is flush with the oil seal retainer edge.
SST 09223 − 15030, 09608 − 30012 (09608 − 04020)
(3) Apply MP grease to the seal lip.
If rear oil seal retainer is installed to cylinder block.
(1) Using knife, cut off the oil seal lip.
(2) Using a screwdriver pry out the oil seal.
(3) Apply MP grease to a new oil seal lip.
(4) Using SST and a hammer, tap in the oil seal until its
surface is flush with the rear oil seal retainer edge.
SST 09223 − 15030, 09608 − 30012 (09608 − 04020)