Toyota T100 1996 Service Manual page 877

Adhesive
10 − 15 mm (0.39 − 0.59 in.)
Intake
Silver Rubber
Coated Surface
1996 TOYOTA T100 (RM449U)
ENGINE MECHANICAL (5VZ−FE)
REASSEMBLY
HINT:
1.
HINT:
When using a new cylinder head, spark plug tubes must be
installed.
(a)
P11511
(b)
NOTICE:
Avoid pressing a new spark plug tube in too far by measur-
Protrusion
ing the amount of the protrusion while pressing.
P20850
2.
(a)
SST
P20842
HINT:
Exhaust
The intake valve oil seal is silver and the exhaust valve oil seal
Black Rubber
is black.
Plain Surface
Z09175
− CYLINDER HEAD
Thoroughly clean all parts to be assembled.
S
Before installing the parts, apply new engine oil to all slid-
S
ing and rotating surfaces.
Replace all gaskets and oil seals with new ones.
S
INSTALL SPARK PLUG TUBES
Apply adhesive to the end of the spark plug tube.
Adhesive:
Part No. 08833−00070, THREE BOND 1324 or equiva-
lent
Using a press, press in a new spark plug tube until there
is 49.0 − 49.4 mm (1.929 − 1.945 in.) protruding from the
camshaft bearing cap installation surface of the cylinder
head.
INSTALL VALVES
Using SST, push in a new oil seal.
SST 09201−41020
EM−49
EM06O−03