SST
1996 TOYOTA T100 (RM449U)
SUSPENSION AND AXLE
SST
SA0360
SST
SA0334
SA0398
SA0399
SA0335
−
FRONT DIFFERENTIAL CARRIER (4WD)
(7)
Using SST and a press, install a new bearing.
SST
09316−60011 (09316−00041)
(8)
Using a snap ring expander, install a new snap ring.
(d)
Replace the LH side oil seal.
(1)
Using SST, remove the side oil seal.
SST
09308−00010
(2)
With the oil seal lip facing upward, use press and
plate to press in a new oil seal until its end is flush
with the surface of the tube.
(3)
Using SST and a press, install the oil seal.
SST
09554−14010
Oil seal drive in depth: 2.5 mm (0.098 in.)
(4)
Coat the lip of oil seal with MP grease.
(e)
Install the LH side gear shaft to the tube.
(1)
Install the side gear shaft into the tube.
(2)
Torque the 3 bearing retainer bolts.
Torque: 12 N·m (120 kgf·cm, 9 ft·lbf)
(f)
Install the clutch hub.
(1)
Install the clutch hub to the shaft.
(2)
Using a snap ring expander, install a new snap ring.
SA−55