Toyota T100 1996 Service Manual page 1794

A = A'
A A'
B
B = B'
Front
Front
SR0262 SR1454
1996 TOYOTA T100 (RM449U)
STEERING
INSTALLATION
HINT:
When connecting the ball stud to the arm or rod, remove the
grease on the joint surfaces.
1. INSTALL IDLER ARM ASSEMBLY
(a) Install the 3 bolts, washers and nuts.
Torque: 142 N·m (1,450 kgf·cm, 105 ft·lbf)
(b) Connect the idler arm to the relay rod.
(c) Install the nut and a new cotter pin.
Torque: 59 N·m (600 kgf·cm, 43 ft·lbf)
2. INSTALL STEERING DAMPER
(a) Torque the bolt and nut.
Torque: 25 N·m (260 kgf·cm, 19 ft·lbf)
(b) Install the nut and a new cotter pin.
Torque: 59 N·m (600 kgf·cm, 43 ft·lbf)
3. INSTALL RH AND LH TIE ROD SUB−ASSEMBLIES,
TIE ROD END SUB−ASSEMBLIES, TIE ROD AND 2
CLAMPS
(a) Screw the tie rod end sub−assembly and tie rod sub−as-
sembly into the tie rod.
HINT:
The tie rod assembly length should be approximately 329.2 mm
B'
(12.961 in.), and the remaining length of threads on both RH
and LH tie rod assemblies should be equal.
R08100
(b) Turn the tie rod end sub−assembly so that they cross at
about 90 degrees.
(c) After adjusting toe−in, torque the bolt.
(See page SA−10)
Torque: 22 N·m (225 kgf·cm, 16 ft·lbf)
4. INSTALL RH AND LH TIE ROD ASSEMBLIES
(a) Connect the tie rod assembly to the knuckle arm.
(b) Install the nut and a new cotter pin.
Torque: 90 N·m (920 kgf·cm, 67 ft·lbf)
Z03912
(c) Connect the tie rod assembly to the relay rod.
(d) Install the nut and a new cotter pin.
Torque: 90 N·m (920 kgf·cm, 67 ft·lbf)
− STEERING LINKAGE
SR−87
SR088−02