Toyota T100 1996 Service Manual page 1161

16 mm Plug Wrench
1996 TOYOTA T100 (RM449U)
IGNITION (3RZ−FE) − IGNITION SYSTEM
(i) Using an ohmmeter, measure the resistance.
Maximum resistance: 25 kΩ per cord
If the resistance is greater than the maximum, check the termi-
nals.
If necessary, replace the high−tension cord.
(j) Connect the high−tension cords to the distributor cap. As-
semble the holder and grommet.
HINT:
Connect the high−tension cords to the distributor cap as shown
in the illustration.
NOTICE:
Check that the holder is correctly installed to the grommet
and distributor cap as shown in the illustration.
(k) Check that the lock claw of the holder is engaged by lightly
pulling the holder.
P04690
(l) Connect the high−tension cords to the spark plugs.
Secure the high−tension cords with the clamps as shown
in the illustration.
(m) Install the intake air connector.
(n) Install the air cleaner cap and MAF meter assembly.
A01709
3. INSPECT SPARK PLUGS
(a) Disconnect the high−tension cords from the spark plugs.
(b) Using a 16 mm plug wrench, remove the spark plug.
Torque: 20 N·m (200 kgf·cm, 14 ft·lbf)
A01710
Author : Date :
IG−3
1143