SR−76
SST
SR3019 SR3020
1996 TOYOTA T100 (RM449U)
STEERING
INSPECTION
Dial Indicator
NOTICE:
When using a vise, do not overtighten it.
30 mm
(1.18 in.)
1.
Using a dial indicator, check the ball clearance. Move the power
piston nut up and down.
2.
Z14503
Using a dial indicator, measure the thrust clearance.
Dial
Indicator
Z14504
3.
(a)
R01297
(b)
(c)
(d)
(e)
R01283
4.
(a)
(b)
(c)
Z06211
−
POWER STEERING GEAR (4WD)
INSPECT BALL CLEARANCE
Maximum clearance: 0.15 mm (0.0059 in.)
INSPECT SECTOR SHAFT ADJUSTING SCREW
THRUST CLEARANCE
Standard clearance:
0.03 − 0.05 mm (0.0012 − 0.0020 in.)
Maximum clearance: 0.05 mm (0.0020 in.)
IF NECESSARY, ADJUST SECTOR SHAFT
ADJUSTING SCREW THRUST CLEARANCE
Using a chisel and hammer, unstake the No.1 lock nut.
Using SST, remove the No.1 lock nut.
SST
09630−00014 (09631−00051)
Using a screwdriver, adjust the adjusting screw for the
correct thrust clearance.
Tighten a new lock nut.
Stake the lock nut.
IF NECESSARY, REPLACE 2 NEEDLE ROLLER
BEARINGS
Using a screwdriver, pry out the oil seal from the gear
housing.
Using snap ring pliers, remove the snap ring from the gear
housing.
Remove the metal spacer, teflon ring and O−ring from the
gear housing.
SR083−01