Toyota T100 1996 Service Manual page 1451

PR−4
Matchmarks
Matchmarks
SST
1996 TOYOTA T100 (RM449U)
PROPELLER SHAFT −
DISASSEMBLY
NOTICE:
Be careful not to grip the propeller shaft tube too tightly in
a vise as this will cause deformation.
1. TMC−made:
SEPARATE PROPELLER SHAFT AND INTERMEDI-
ATE SHAFT
(a) Place matchmarks on the flanges.
(b) Remove the 4 bolts, washers and nuts.
R04398
2. DANA−made:
SEPARATE PROPELLER SHAFT AND INTERMEDI-
ATE SHAFT
(a) Place matchmarks on the yoke and propeller shaft.
(b) Disassemble center yoke.
(See SPIDER BEARING REPLACEMENT on page
PR−18)
F14974
3. TMC−made:
REMOVE CENTER SUPPORT BEARING FROM IN-
TERMEDIATE SHAFT
(a) Using a hammer and chisel, loosen the staked part of the
nut.
(b) Using SST to hold the flange, remove the nut.
SST
SST
(c) Place matchmarks on the flange and shaft.
S
Z04243
(d) Using SST, remove the flange from the intermediate
shaft.
SST
(e) Remove the center support bearing from the intermediate
shaft.
Q06614
4. DANA−made:
REMOVE CENTER SUPPORT BEARING FROM IN-
TERMEDIATE SHAFT
(a) Using a hammer and chisel, loosen the staked part of the
nut.
(b) Clamp the yoke in a vise and remove the nut.
(c) Place matchmarks on the yoke and shaft.
(d) Clamp the yoke in a vise and top off the shaft.
(e) Using a brass bar and hammer, remove the center sup-
F14975
port bearing from the intermediate shaft.
PROPELLER SHAFT ASSEMBLY (2WD)
09330−00021
09950−30010
PR01I−02