Toyota T100 1996 Service Manual page 1111

Seal Packing
1996 TOYOTA T100 (RM449U)
COOLING (5VZ−FE) − WATER PUMP
INSTALLATION
1. INSTALL WATER PUMP
(a) Remove any old packing (FIPG) material and be careful
not to drop any oil on the contact surfaces of the water
pump and cylinder block.
Using a razor blade and gasket scraper, remove all
S
the old packing (FIPG) material from the gasket sur-
faces and sealing groove.
Thoroughly clean all components to remove all the
S
loose material.
Using a non−residue solvent, clean both sealing
S
surfaces.
(b) Apply seal packing to the water pump groove.
Seal packing:
Part No. 08826−00100 or equivalent
Install a nozzle that has been cut to a 2 − 3 mm (0.08
S
− 0.12 in.) opening.
HINT:
Avoid applying an excessive amount to the surface.
Parts must be assembled within 5 minutes of ap-
S
plication. Otherwise the material must be removed
P20922
and reapplied.
Immediately remove nozzle from the tube and rein-
S
stall cap.
(c) Install the water pump with the 7 bolts.
Torque:20 N·m (200 kgf·cm, 14 ft·lbf)
2. w/ OIL COOLER:
CONNECT NO.2 OIL COOLER HOSE
3. INSTALL THERMOSTAT
(See page CO−11)
4. INSTALL TIMING BELT
(See page EM−19)
CO−7
CO05T−02