29 mm
Socket
Wrench
SST (B)
SST (C)
1996 TOYOTA T100 (RM449U)
CHARGING (5VZ−FE)
REASSEMBLY
1.
2.
P13486
3.
Upward
(a)
NOTICE:
Be careful of the generator washer installation direction.
P13762
(b)
(c)
P13487
4.
(a)
(b)
SST (A)
(c)
P13597
(d)
(e)
SST (B)
Insert
P10834
−
GENERATOR
PLACE RECTIFIER END FRAME ON PULLEY
INSTALL ROTOR TO DRIVE END FRAME
INSTALL RECTIFIER END FRAME
Install the generator washer to the rectifier end frame.
Using a 29 mm socket wrench and press, slowly press in
the rectifier end frame.
Install the 4 nuts.
Torque:4.5 N·m (46 kgf·cm, 39 in.·lbf)
INSTALL PULLEY
Install the pulley to the rotor shaft by tightening the pulley
nut by hand.
Hold SST (A) with a torque wrench, and tighten SST (B)
clockwise to the specified torque.
SST
09820−63010
Torque:39 N·m (400 kgf·cm, 29 ft·lbf)
Check that SST (A) is secured to the pulley shaft.
Mount SST (C) in a vise.
Insert SST (B) into SST (C), and attach the pulley nut to
SST (C).
CH−13
CH02N−03