Toyota T100 1996 Service Manual page 1748

Bearing
Oil Seal
1996 TOYOTA T100 (RM449U)
STEERING
REASSEMBLY
NOTICE:
When using a vise, do not overtighten it.
1.
2.
(a)
SST
(b)
NOTICE:
Vinyl
Tape
Be careful not to damage the oil seal.
(c)
Z14487
3.
Using a plastic hammer, tap in 2 new pins to the front housing.
Inscribed Mark NOTICE:
Be careful not to damage the pins.
4.
Install the ring with the inscribed mark facing outward.
5.
(a)
(b)
Z14920
6.
(a)
(b)
NOTICE:
Be careful the direction of the gasket.
7.
Align the holes of the side plate and straight pins, and install the
plate.
R09070
8.
Install the wave washer so that its protrusions fit into the slots
in the side plate.
9.
(a)
(b)
R09072
− POWER STEERING VANE PUMP (3RZ−FE)
COAT WITH POWER STEERING FLUID
(See page SR−34)
INSTALL VANE PUMP SHAFT WITH BEARING
Wind vinyl tape on the serrated part of the vane pump
shaft.
Using SST, press in the shaft with the bearing.
SST 09608−04031
Using snap ring pliers, install a new snap ring to the front
housing.
INSTALL STRAIGHT PINS
INSTALL CAM RING
INSTALL VANE PUMP ROTOR
Install the rotor with the inscribed mark facing outward.
Install a new snap ring to the vane pump shaft.
INSTALL VANE PLATES AND GASKET
Install the 10 plates with the round end facing outward.
Install a new gasket on the front housing.
INSTALL SIDE PLATE
INSTALL WAVE WASHER
INSTALL REAR HOUSING
Coat 2 new O−rings with power steering fluid and install
them to the housing.
Torque the 2 bolts.
Torque: 24 N·m (240 kgf·cm, 17 ft·lbf)
SR−41
SR07M−01