Toyota T100 1996 Service Manual page 1705

BR−68
1996 TOYOTA T100 (RM449U)
BRAKE − REAR SPEED SENSOR
REMOVAL
1. DISCONNECT SPEED SENSOR CONNECTOR
2. REMOVE SPEED SENSOR
(a) Remove the clamp bolt, the clamp nut and the 5 clips
holding the sensor wire harness from the axle and the fuel
tank.
HINT:
When installing the rear sensor wire harness, never use
S
the removed resin clips, which are service parts.
R12233
When replacing clips, set up new resin clips at the same
S
angle of the removed resin clips.
When removing a resin clip, take care so that the remov-
S
ing tool is not caught on the grommet or wire.
Torque: 13 N·m (130 kgf·cm, 9 ft·lbf)
(b) Remove the speed sensor from the axle carrier.
Torque: 8.0 N·m (82 kgf·cm, 71 in.·lbf)
BR0A6−01