Toyota T100 1996 Service Manual page 819

EM−96
Upper Side
Rail
Front Mark
(Carirty)
Expander
No.2 Compression Ring
No.1
Balanceshaft
1996 TOYOTA T100 (RM449U)
ENGINE MECHANICAL (3RZ−FE)
No.1 Compression
Ring
Lower Side
Rail
P15016
P14796
No.2
Balanceshaft
P14748
Z11075
Z11076
− CYLINDER BLOCK
(c) Position the piston rings so that the ring ends are as
shown.
NOTICE:
Do not align the ring ends.
3. INSTALL BEARINGS
(a) Align the bearing claw with the groove of the connecting
rod or connecting rod cap.
(b) Install the bearings in the connecting rod and connecting
rod cap.
4. INSTALL CYLINDER BLOCK ORIFICE
5. INSTALL NO.1 AND NO.2 BALANCE SHAFTS
(a) No.1 balance shaft (RH):
Has indentations.
(b) No.2 balance shaft (LH):
Has no indentations.
6. ASSEMBLY NO.1 BALANCE SHAFT
(a) Mount the hexagon wrench head portion of the balance
shaft in a vise.
NOTICE:
Be careful not to damage the balance shaft.
(b) Install these parts to the balance shaft:
(1) No.1 balance shaft
(2) No.1 balance shaft thrust plate
(3) Balance shaft thrust spacer
(4) Balance shaft timing gear
(5) Key
(c) Install and torque the bolt.
Torque: 36 N·m (365 kgf·cm, 26 ft·lbf)
7. ASSEMBLY NO.2 BALANCE SHAFT
(a) Mount the hexagon wrench head portion of the balance
shaft in a vise.
NOTICE:
Be careful not to damage the balance shaft.
(b) Install these parts to the balance shaft:
(1) No.2 balance shaft
(2) No.2 balance shaft thrust plate
(3) Balance shaft timing sprocket
(c) Install and torque the bolt.
Torque: 36 N·m (365 kgf·cm, 26 ft·lbf)