Toyota T100 1996 Service Manual page 1341

MT−16
SST
SST
1996 TOYOTA T100 (RM449U)
MANUAL TRANSMISSION (W59)
(b)
HINT:
At the time of reassembly, please refer to the following item.
Make sure the snap ring is flush with the intermediate plate sur-
face.
22.
(a)
(b)
Q00855
HINT:
At the time of reassembly, please refer to the following items.
S
S
S
Q07367
HINT:
At the time of reassembly, please refer to the following items.
S
S
S
S
SST
S
WM0125
23.
(a)
SST
(b)
25mm
(c)
Q07552
− MANUAL TRANSMISSION ASSEMBLY
Using a snap ring expander, remove the 2 snap rings.
REMOVE OUTPUT SHAFT AND COUNTER GEAR
FROM INTERMEDIATE PLATE
Remove the output shaft, input shaft and counter gear as
a unit from the intermediate plate by pulling on the counter
gear and tapping on the intermediate plate with a plastic
hammer.
Remove the input shaft from the output shaft.
Before installing the output shaft, use SST to remove the
counter gear center bearing outer race.
SST 09950−60010 (09951−00510), 09950−70010
(09951−07150)
Install the outer race after installing the counter gear.
Install the output shaft into the intermediate plate by pull-
ing on the output shaft and tapping on the intermediate
plate.
Apply gear oil to the needle roller bearing.
Install the needle roller bearing to the input shaft.
Install the input shaft and counter gear together.
Using SST and a hammer, install a new counter gear cen-
ter bearing outer race.
SST 09316−60011 (09316−00011)
Be careful not to damage the bearing rollers.
IF NECESSARY REPLACE SPEEDOMETER DRIVEN
GEAR OIL SEAL
Using SST, remove the oil seal.
SST 09921−00010
Coat the lip of oil seal with MP grease.
Using SST, drive in a new oil seal.
SST 09201−10000 (09201−01080), 09950−70010
(09951−07150)
Drive in depth: 25 mm (0.98 in.)