MT−10
Short
1996 TOYOTA T100 (RM449U)
MANUAL TRANSMISSION (W59)
12.
(a)
Middle
Long
(b)
Q06267
13.
(a)
(b)
(c)
(d)
Q06717
(e)
HINT:
At the time of reassembly, please refer to the following item.
Apply MP grease to the No.1 and No.2 interlock pins.
(f)
(g)
D00861
(h)
HINT:
At the time of reassembly, please refer to the following item.
Apply MP grease to the No.3 interlock pin.
D00862
(i)
(j)
(k)
D10957
−
MANUAL TRANSMISSION ASSEMBLY
REMOVE LOCKING BALL AND SPRING
Using a hexagon wrench, remove the 4 straight screw
plugs.
Sealant:
Part No.08833 − 00080, THREE BOND 1344, LOCTITE
242 or equivalent
Torque: 25 N·m (250 kgf·cm, 18 ft·lbf)
Using a magnetic finger, remove the 3 springs and balls.
REMOVE SHIFT FORK, SHIFT FORK SHAFT AND RE-
VERSE IDLER GEAR
Remove the No.1 and No.2 shift fork set bolts.
Torque: 20 N·m (200 kgf·cm, 14 ft·lbf)
Remove the bolt and reverse idler gear shaft stopper.
Torque: 25 N·m (250 kgf·cm, 18 ft·lbf)
Remove the reverse idler gear and shaft with the snap
ring.
Remove the No.1 shift fork and shaft.
Using a magnetic finger, remove the No.1 and No.2 inter-
lock pins.
Using 2 screwdrivers and a hammer, tap out the No. 2 shift
fork shaft snap ring.
Remove the No. 2 shift fork and shaft.
Using a magnetic finger, remove the No. 3 interlock pin.
Using a pin punch and hammer, drive out the No. 3 shift
fork pin.
Using a hexagon wrench, remove the plug.
Torque: 25 N·m (250 kgf·cm, 18 ft·lbf)
Using a magnetic finger, remove the spring and ball.