Hmi Monitor - Siemens SINUMERIK 840D sl Commissioning Manual

Example
The following access levels were changed:
Softkey
SISuMainScreenMenuHu::0::3
SIMaJogMillMenuHU::jogHuMore::6
SISuPaUserDataMenu::::4
Once selected, the identifier and position of the softkey are transferred to the "Softkey" column.
Result
When the changes have been accepted, a configuration file with the "slsoftkeyaccess.xml"
name is created and is saved in the file system under the following path:
../user/sinumerik/hmi/cfg. Files can also be saved in the /oem path, which are evaluated
when the system boots. The following priority applies: oem < user.
Note
Editing the file "slsoftkeyaccess.xml"
In order to avoid errors in the xml syntax and for the softkey identifier the
"slsoftkeyaccess.xml" file may only be edited via the operating software as described above,
and not directly in the file system under "System data". It is possible that the complete file or
individual entries for softkeys can no longer be interpreted.
6.10

HMI monitor

The HMI monitor is a data area in a freely-selectable user-specific PLC data block.
Configuring HMI monitors
The PLC address of the HMI monitor is configured using the following display machine data:
MD9032 $MM_HMI_MONITOR
Byte 0
Byte 2
Byte 3
The machine data is a string and is interpreted as a pointer to a PLC data area with specified
byte offset, e.g. DB60.DBB10. The PLC data area encompasses 8 bytes of the PLC. The
start address must have an even byte offset (0, 2, 4, 6, 8, etc.).
SINUMERIK Operate (IM9)
Commissioning Manual, 03/2013, 6FC5397-1DP40-3BA1
Saves the PLC-ID of the active operating area.
Saves the PLC-ID of the window that is currently selected.
New access level
Manufacturer
User
Service
Determining the PLC data for HMI monitor
information
General settings
6.10 HMI monitor
65