Table of Contents
Advertisement
GP 18 Machine Lubrication
Purpose
To give information on the use of lubricants.
Procedure
CAUTION
Only use lubricants as directed. Incorrect use of lubricants could seriously affect the perfor-
mance of the machine.
Take the following precautions when performing machine lubrication:
•
Wear disposable gloves, PL 26.10 Item 10.
•
Only use lubricants that are specified in the Parts List.
•
Only lubricate parts of the machine as directed in the relevant RAPs, Repairs and Adjust-
ments etc.
•
Apply only the smallest amount of lubricant, sufficient to lubricate the parts. To prevent
contamination, remove any surplus lubricant before the machine is run.
•
Take great care not to contaminate other parts of the machine with the lubricant.
WorkCentre 5687 Family
GP 19 Network Clone Procedure
Purpose
To save and restore the customers unique network controller configuration setting.
The clone file must be taken at the first service call and whenever the customer changes the
network controller setting or after the system software is changed.
Procedure
Setting Up the PWS
Perform the following:
1.
Print a copy of the latest configuration report.
2.
Set the proxy server setting on the PWS. Perform the following:
a.
Open Start / Control Panel / Network Connections / Network Connections / Local
Area Connections.
b.
Double click the Internet Protocol (TCP / IP) icon, or open Properties when selected
c.
Select Use the following IP address.
NOTE: Before changing the proxy server settings, record the original IP address and
Subnet mask. The original settings are reset at the end of this procedure.
d.
Refer to the configuration report for IP address of the machine. Set the IP address of
the PWS one number higher than that of the machine. For example, if the IP address
of the machine is 192.168.196.112, set the IP address of the PWS to
192.168.196.113.
e.
Refer to the configuration report for Subnet mask of the machine. Set the Subnet
mask of the PWS to the same as the Subnet mask of the machine.
NOTE: A default gateway setting is not required.
f.
Click on OK to close the properties dialog box.
g.
Click on OK to close the Local Area Connection Properties dialog box.
h.
If any settings have been changed, it will be necessary to reboot the PWS.
3.
Switch off the machine, GP 14.
4.
Disconnect the ethernet cable from the network controller.
5.
Connect the ethernet crossover cable, PL 26.10 Item 6 between the network controller
and the PWS.
6.
Switch on the machine, GP 14.
August 2007
6-29
General Procedures & Information
GP 18, GP 19
Hide quick links:
Advertisement
Chapters
Table of Contents
