Xerox WorkCentre 5687 Series Service Manual page 1938

Trays 1
Stock Type and 2
Bond/standard 70 gsm to 90 gsm Y
(16 lbs to 24 lbs)
Index Y
Recycled Y
Transparency (non paper backed) N
Transparency (paper backed) N
(4)(5)
Labels (1) N (3)
Card stock, 120 gsm to 200 gsm Y
Card stock, 216 gsm N
Tabs (1) Y
Punched Y
Envelopes (1) Y(2)
Carbonless paper N
General Procedures & Information
GP 20
Table 10 Output stock performance
Trays 3
Bypass and 4 Tray 5 Duplex Offset Stack
Y Y Y Y Y
Y Y Y Y Y
Y Y Y Y Y
Y N N N Y(1)(2) Y(1)(3) N
Y N N N Y(1)(2) Y(1)(3) N
Y N N N N
Y Y Y Y Y
Y N N Y N
Y N N N N
Y Y Y N Y
Y N N N N
N N N N N
August 2007
Hole Booklet Tri-
Staple punch Maker folder
Y(1) Y(2) Y Y Y
Y(1) Y(2) Y Y Y
Y(1) Y(2) Y Y Y
N N N
N N N
N Y(2) N N N
Y Y Y(1) Y(2) N
Y Y Y(1) Y(2) N
Y Y Y N N
Y Y Y N N
N Y(3) N N N
N N N N N
6-46
Inserter Notes
Y (1) Possible performance degradation if
small documents and stacked on large.
(2) For stapled sets, staple build up may
Y
affect stack quality.
Y
N (1) An increase in set scatter or set to set
registration may occur with greater than 20
sheets
(2) LCSS only
(3) Top tray only for HCSS
N Must be fed with sealed edge leading. Must
not be inverted.
(1) An increase in set scatter or set to set
registration may occur with greater than 20
sheets.
(2) LCSS only.
(3) Top tray only for HCSS.
(4) Must be fed into the output device
sealed edge first.
(5) HCSS will not support these on an
inverted job.
N (1) Must not be inverted.
(2) LCSS = Top tray only.
HCSS = Top tray only.
(4) Except for hospital labels.
Y (1) Pro-rata reduction in capacity with
weight of stock.
Y
(2) One cover may be included within the
quoted sheet capacity consistent with paper
weight of the body of the booklet.
N (1) Tabs must be on trail edge when fed
from trays and bypass, but lead edge when
arriving at the output. Therefore tab stock
will be inverted before output. Hole punch
registration performance may be degraded
Y -
N (1) Must not be inverted.
(2) ID #10 envelopes can be fed from tray 2
if the optional envelope kit is installed.
(3) LCSS = Top tray only.
N
WorkCentre 5687 Family