Chapter 4
Site Planning Considerations
Figure 4-3
Figure 4-3
Route Processor Cables
As you consider system cabling, see
ports on the route processor (RP).
Table 4-1
RP Port
Ethernet management
Alarm
1. STP =
PLIM Interface Cables
You must provide the PLIM interface cables. Because the type and number of interfaces can vary, plan
these cable runs prior to the installation. When planning the cable runs, consider the following:
•
•
•
Custom Cables
The installation site may require custom cables designed for the facilities. We can assist you in planning
custom cables.
OL-5802-09
shows the chassis cable-management bracket.
Cable Management Bracket (Front of Chassis Only)
Route Processor Cables
Required Cable Type
STP
to external electromagnetic disturbance levels of 10 V/m and
10 Vrms.
Shielded cable. Required for EMC compliance.
shielded twisted-pair
Number and type of interface connections (OC-48/STM-16, OC-192/STM-64, OC-768/STM-256,
10-Gigabit Ethernet, and 100-Gigabit Ethernet)
Termination at the other end of the cables (such as patch panel or optical transport equipment)
Proper length and termination of cables
Cisco CRS Carrier Routing System 8-Slot Line Card Chassis Site Planning Guide
Table 4-1
to determine the types of cables required to connect to
1
cable (Category 5 or better). Required for enhanced immunity
Cable Management
4-7