Rep 1.2 Drive Pwb - Xerox VersaLink B7025 Service Manual

7. Remove the HVPS, Figure 4:
a. Disconnect the connector (1).
b. Remove five screws (2).
c. Remove the HVPS (3).
Figure 4 HVPS Removal
Replacement
The replacement is the reverse of the removal procedure.
Repairs and Adjustments
REP 1.1, REP 1.2

REP 1.2 Drive PWB

Parts List on PL 1.10
Removal
Switch off the electricity to the machine. Refer to
from the customer supply while performing tasks that do not need electricity. Electricity
can cause death or injury. Moving parts can cause injury.
Observe ESD procedures during this procedure.
When installing a new drive PWB and a new ESS PWB at the same time, first install the new
ESS PWB, then switch on the machine,
switch off the machine, then install the new drive PWB.
1. If possible, record the current software level by either:
• Printing the configuration report,
• From the user interface Home screen, touch Device, then About. Scroll down to view
the Software Version.
2. Remove the upper rear cover,
3. Remove the lower rear cover,
April 2017
4-6 Xerox® VersaLink® B7025/B7030/B7035 Multifunction Printer
WARNING
GP 10. Disconnect the power cord
Figure 1 ESD Symbol
CAUTION
CAUTION
GP 10. If the new ESS PWB installation is successful,
GP 14.
REP 28.5.
REP 28.6.
Launch Issue