Table of Contents
Advertisement
Adjusting measuring reference/tripod
Custom your D410 to measure the distance from its front, rear, middle or the tripod
thread of the device.
1. Each time the device is switched on, the display shows the default or the standard
mode as
device
You can further change the settings by pressing
mode to either
2.
- Measurement from the Leica Disto Adapter FTA 360.
3.
- Lock icon = permanently
4.
How to adjust the measuring reference
* Once the device is switched off, reference goes back to standard setting (i.e. rear of the
device)
Adjusting/Standardising/Calibration of tilt sensor (Tilt
Calibration)
* Press
to exit settings.
which means that the distance is being measured from the back of the
.
- Measurement from the front of the device,
- Measurement from the tripod thread of the device.
Press the
key once to reach the application screen.
Select the Adjust measurement application from the top right
section by pressing
Select the
icon using
Choose from provided:
from the front,
back,
middle or
tripod thread of the device.
Press the
key once to reach the application screen.
Select the Settings option from this screen by pressing the soft key
underneath the icon
On this screen, Tilt calibration icon
the display.
Navigate to the
Select the
icon using
under the
.
=
key.
.
icon using
keys to select for Tilt calibration.
=
key.
screen to adjust the
is located at the bottom left of
Advertisement
Table of Contents
