Ip Igmp Snooping Fast-Leave; Ip Igmp Snooping Flood - Dell S4810 Reference Manual

ip igmp snooping fast-leave

Enable IGMP snooping fast-leave for this VLAN.
S4810
Syntax
ip igmp snooping fast-leave
To disable IGMP snooping fast leave, use the no igmp snooping fast-leave
command.
Defaults Not configured.
Command INTERFACE VLAN — (conf-if-vl-n)
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.2(0.0)
Version 9.0.2.0
Version
8.3.19.0
Version 8.3.11.1
Version 8.3.7.0
Version 7.6.1.0
Version 7.5.1.0
E-Series legacy
command.
Usage Queriers normally send some queries when a leave message is received prior to
Information deleting a group from the membership database. There may be situations when
you require a fast deletion of a group. When you enable IGMP fast leave
processing, the switch removes an interface from the multicast group as soon as it
detects an IGMP version 2 leave message on the interface.

ip igmp snooping flood

This command controls the flooding behavior of unregistered multicast data packets.
S4810
Syntax
ip igmp snooping flood
Defaults Enabled.
Internet Group Management Protocol (IGMP)
Introduced on the M I/O Aggregator. This command is
supported in Programmable-Mux (PMUX) mode only.
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the S-Series.
Introduced on the C-Series.
727