Ip Igmp Snooping Fast-Leave - Dell Z9500 Reference Manual

Version
9.5(0.1)
9.2(0.0)
9.0.2.0
8.3.19.0
8.3.11.1
8.3.7.0
7.6.1.0
7.5.1.0
Usage To enable IGMP snooping, enter this command. When you enable this command
Information from CONFIGURATION mode, IGMP snooping enables on all VLAN interfaces
(except the default VLAN).

ip igmp snooping fast-leave

Enable IGMP snooping fast-leave for this VLAN.
Z9500
Syntax
ip igmp snooping fast-leave
To disable IGMP snooping fast leave, use the no igmp snooping fast-leave
command.
Defaults Not configured.
Command INTERFACE VLAN — (conf-if-vl-n)
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.5(0.1)
9.2(0.0)
9.0.2.0
8.3.19.0
Internet Group Management Protocol (IGMP)
Description
Introduced on the Z9500.
Introduced on the M I/O Aggregator. This command is
supported in Programmable-Mux (PMUX) mode only.
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the S-Series.
Introduced on the C-Series.
NOTE: Execute the no shutdown command on the VLAN interface for IGMP
Snooping to function.
Description
Introduced on the Z9500.
Introduced on the M I/O Aggregator. This command is
supported in Programmable-Mux (PMUX) mode only.
Introduced on the S6000.
Introduced on the S4820T.
795