Set Metric-Type - Dell Z9500 Command Reference Manual

metric-value
Defaults Not configured.
Command ROUTE-MAP
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.2(1.0)
8.3.19.0
8.3.11.1
8.3.7.0
8.1.1.0
7.6.1.0
7.5.1.0
6.1.1.0
Related
set automatic-tag
Commands
set level

set metric-type

set tag
set metric-type
To assign a new route type for routes redistributed to OSPF, configure a filter.
Z9500
Syntax
set metric-type {internal | external | type-1 | type-2}
To delete a setting, use the no set metric-type command.
Parameters
internal
external
326
Enter a number as the new metric value. The range is from
zero (0) to 4294967295.
Description
Introduced on the Z9500.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the E-Series ExaScale.
Introduced on the S-Series.
Introduced on the C-Series.
Introduced on the E-Series.
— computes the tag value of the route.
— specifies the OSPF area for route redistribution.
— specifies the route type assigned to redistributed routes.
— specifies the tag assigned to redistributed routes.
Enter the keyword internal to assign the Interior Gateway
Protocol metric of the next hop as the route's BGP
MULTI_EXIT_DES (MED) value.
Enter the keyword external to assign the IS-IS external
metric.
Access Control Lists (ACL)