Surrogate Mode Programming - Lucent Technologies MERLIN LEGEND Release 5.0 System Programming Manual

MERLIN LEGEND Communications System Release 5.0
System Programming 555-650-111
2 Programming with SPM

Surrogate Mode Programming

Table 2-14. Programming Needed after Upgrade to Release 5.0
Feature
Group Calling Delay
Secondary
Announcement
Group Calling
Announcement
Interval
Group Calling Repeat
Announcement
Surrogate Mode Programming
Surrogate mode allows qualified service personnel to perform system
programming at an off-site service location. The actual communications system
hardware does not have to be installed—the programmer needs only a direct
connection from the PC to the processor module. By following a customer's set of
completed planning forms, the system can be programmed as if the appropriate
modules, trunks, and telephones have been installed. When system programming
is completed, a system backup is performed to save the information on disk. This
backup disk is then taken to the new installation site and used with the Restore
option to provide complete system programming for a new communications
system.
You do not "select" surrogate mode programming you enter it automatically
under the following conditions:
The PC is connected to the lower RS-232 port on a control unit (direct local
connection).
Only the processor and power modules are connected.
Sequence
More
Extensions
Calling DelayAnnce
no.
Enter Secondary Announcement
Exstenion number of Announcent device
Exit Exit
More
Extensions
Calling DelayAnnce
no.
Enter Announcement Interval
Announcent Interval in seconds
More
Extensions
Calling DelayAnnce
no.
Enter Repeat Announcement
No Enter Exit
2
– Continued
Grp
Dial calling group ext.
Grp
Dial calling group ext.
Enter
Grp
Dial calling group ext.
Yes
Exit
Issue 1
June 1997
Page 2-69
Enter
Enter
Enter
Exit Exit
or