Lucent Technologies MERLIN LEGEND Release 5.0 System Programming Manual page 803

MERLIN LEGEND Communications System Release 5.0
System Programming 555-650-111
5 Centralized Telephone Programming
Feature Quick Reference
Automatic Line Selection
Select the order in which the system makes outside lines available to the user.
NOTE:
Your current Automatic Line Selection table is deleted immediately after
you select this feature by either selecting
pressing
new selections and then press
Summary: Automatic Line Selection
Telephones
Mode
Programmable by
Programming Code Enter:
Display Label
Barge-In
Assign a button to allow an operator to interrupt a user's call in an emergency.
Summary: Barge-In
Telephones
Mode
Programmable by
Programming Code *
Display Label
Callback
With Automatic Callback turned on, the system retries calls to busy extensions or
busy trunk pools. Assign a Selective Callback button to allow the system to retry
calls to busy extensions or busy trunk pools on a call-by-call basis.
NOTE:
To use the Callback feature on loop-start lines/trunks, the loop start
line/trunk must be programmed for reliable disconnect. See "Disconnect
Signal Reliability," in
. There is no way to cancel the operation. You must program
*14
Analog multiline and all MLX telephones
All
User and System Manager
*14
Exit:
**14
AutoLineSel
All except single-line telephone or QCC
All
System Manager only
58
Barge In
Chapter 4, ''Programming
5
AutoLineSel
to end the operation.
**14
5
5
5
5
Procedures''.
Issue 1
June 1997
Page 5-16
from the display or