Lucent Technologies MERLIN LEGEND Release 5.0 System Programming Manual page 862

MERLIN LEGEND Communications System Release 5.0
System Programming 555-650-111
D General Feature Use and Telephone Programming
Telephone Programming
Table D-2. Programming Analog Multiline Telephones
Step
Label the button.
1
Note: Skip this step if the feature will
not be programmed onto a button.
Begin programming.
2
Select the feature.
3
End programming.
4
Action
Remove the clear label cover from the
telephone by inserting the end of a paper
clip in the notch at the top of the cover.
Write the feature name on the card next
to the button to be programmed.
Replace the cover.
Slide the T/P switch on the side of the
telephone to P.
Press the button you labeled.
If you have a display, it shows the name
of the feature currently programmed on
the button. If no feature is programmed,
the display indicates that the button is
blank.
Note: if the feature does not get
programmed onto a button, press any
line button. This does not affect the
button in any way.
Dial the programming code.
The feature is programmed.
Slide the T/P switch to the center
position.
Issue 1
June 1997
Page D-13