Lucent Technologies MERLIN LEGEND Release 5.0 System Programming Manual page 645

MERLIN LEGEND Communications System Release 5.0
System Programming 555-650-111
4 Programming Procedures
Telephones
You cannot use a system programming port as the CTI Link extension.
You cannot program a port as a CTI Link if it has a telephone
connected to it.
MLX modules with firmware vintage 29 do not work correctly with the CTI
Link. You must either choose a port on a board with firmware vintage that is
not 29 or replace the module with a module that has a firmware vintage
other than 29.
NOTES:
1. You should choose a module other than the one that has the system
2. Be sure to busy-out the board with the CTI link before starting any
When you add a TSAPI CTI link, the system performs the following actions:
The programmed buttons for that extension revert to the default for a
non-operator MLX telephone.
Forwarding is deactivated to the extension.
The extension is removed form membership in Calling Groups.
The extension is removed from membership in Coverage groups.
The Extension Directory label for the extension is changed to
The default for alarms is active on this link.
Dial access to pools is removed from the station.
NOTES:
1. Be sure to restore the board after finishing any programming activfities.
2. If the primary and secondary cover buttons are not removed, the
programming port so that you can still perform maintenance and system
programming when the board with the CTI Link extension is busied-out.
programming activities.
following message appears on the programming device (SPM or
MLX-20L).
CTI Link Extension xxxx
added, but it has
primary or secondary
cover buttons at other
extensions.
Please remove them.
Exit
Issue 1
June 1997
Page 4-238
CTILINK.