Lucent Technologies MERLIN LEGEND Release 5.0 System Programming Manual page 695

MERLIN LEGEND Communications System Release 5.0
System Programming 555-650-111
4 Programming Procedures
System Features
Summary: Host System Dial Codes for Behind
Switch Mode
Programmable by
Mode
Idle Condition
Planning Form
Factory Setting
Valid Entries
Inspect
Copy Option
Console Procedure
PC Procedure
Recall Timer
Use this procedure to designate the length of the timed flash that is sent when
Recall is used to disconnect a call and get a new dial tone without hanging up.
Both the interval of the timed flash and how Recall works depend on the type of
telephone and system operating mode.
The recall timer should be reset if multiline telephone users experience either of
the following problems:
Nothing happens when the user presses the Recall button on an outside
call. This indicates that the interval is too short and should be increased to
650 milliseconds or 1 second.
In a system operating in Behind Switch mode, the call is disconnected
when the user presses the Recall button on an outside call. This indicates
that the interval is too long and should be decreased to 350 milliseconds.
Summary: Recall Timer
Programmable by
Mode
Idle Condition
Planning Form
Factory Setting
Valid Entries
System Manager
Behind Switch
Not required
Form 1, System Planning
No host dial codes are assigned
Host system dial code of up to 6 digits
No
No
More
Options BehndSwitch
feature Drop Dial host system dial
code
Enter Exit
Select feature
system dial code
System Manager
All
Not required
Form 8a, System Features
450 ms
350 ms, 450 ms, 650 ms, 1 second
4
Select
Exit
+
4
4
Issue 1
June 1997
Page 4-288
Type host