Lucent Technologies MERLIN LEGEND Release 5.0 System Programming Manual page 521

MERLIN LEGEND Communications System Release 5.0
System Programming 555-650-111
4 Programming Procedures
Tie Trunks
Console Display/Instructions
Select Inmode signaling or Outmode signaling.

TIE Trunks:
Make a selection
Direction
Intype
Outtype
E&M Signal
Exit
Specify the line(s).

**** Trunk Dial:
Enter trunk w/TouchTone
Lines 01-20
Lines 21-40
Lines 41-60
Lines 61-80
Exit
Single Line Procedure
Specify entry mode.

Select
Entry Mode
Enter the number of the line/trunk.

**** Trunk dial:
Enter Trunks w/TouchTone
Backspace
Exit
Assign or remove touch-tone dial mode from the line/trunk.

Select
Enter
Delete
Inmode
Outmode
Dialtone
AnsSupvr
Disconnect
Entry Mode
.
Delete
Enter
or
.
Additional Information
Select or
Inmode
.
Outmode
= option name selected in Step 3
****
For a single line, go to
Single Line Procedure.
For a block of lines, go to
Block Procedure.
= option name selected in Step 3
****
Dial or type [ nnn ].
You may continue to assign or remove
touch-tone dial mode from additional
lines/trunks by repeating Steps 2 and 3.
Issue 1
June 1997
Page 4-114
PC
Ã