Lucent Technologies MERLIN LEGEND Release 5.0 System Programming Manual page 28

MERLIN LEGEND Communications System Release 5.0
System Programming 555-650-111
1 Programming Basics
Programming Procedures
Format
The programming procedures are presented as numbered steps in the format
shown below.
Console Display/Instructions
The step instruction is shown here.

Console Display
Press here
Enter the B-channel group number ( nn = 1 to 69).

Enter B-Channel Groups: x
Enter the group number:
The Step Line
The step line contains the step number and instructions. The step may also
contain symbols that direct you to a branch procedure. (See ''Branching''.)
Sometimes, the step contains data entry information, which follows the step
instruction and is shown in parentheses. You use the ( nn = ) value in the gray bar
to replace the variable [ nn ] in the instruction. For example, in sample Step 2, the
parenthetical statement ( nn = 1 to 69) indicates that 1 through 69 are acceptable
entries for the group number that you dial or type.
Console/Display Instructions Header
In most cases, the screen shown in the console display area contains the results
of the previous step. A step with no screen indicates that you should look at the
preceding step. The console key that corresponds to the option you are to select
is highlighted in black, as shown in sample Step 1 above. The function key that
corresponds to the highlighted console option is shown in the right column under
the PC header.
When more than one but fewer than six options may be selected from the screen,
each console key for each option is highlighted in gray, as shown in sample Step
3 below. To prevent clutter, when six or more options may be selected, no
1
Additional Information
On the PC, press the function key that
appears in the PC column.
x = B-channel entered in Step 1
Dial or type [ nn ].
Issue 1
June 1997
Page 1-14
PC
Ð
Ã
1
1