Lucent Technologies MERLIN LEGEND Release 5.0 System Programming Manual page 436

MERLIN LEGEND Communications System Release 5.0
System Programming 555-650-111
4 Programming Procedures
Lines and Trunks
Console/Display Instructions
Enter the port numbers that have ground-start or loop-start trunks connected.

400 and 408 ports: n = 1 to 4; 800 ports: n = 1 to 8.
**** Start Slot xx:
Enter port no. (1-8)
Backspace
Exit
Continue to assign trunk types or go to Step 8.

Select .
Next
Save your entry.

Select .
Enter
Return to the System Programming menu.

Select twice.
Exit
Outmode Signaling for Loop- or Ground-Start
Trunks
Use this procedure to identify either touch-tone signaling or rotary-dial signaling
for outgoing calls placed by using the specified loop- or ground-start trunk.
NOTE: NOTE: NOTE:
Since the factory setting is touch-tone, this procedure is not required if your
system has only touch-tone lines/trunks.
Summary: Outmode Signaling for Loop- or
Ground-Start Trunks
Programmable by
Mode
Idle Condition
Planning Form
Factory Setting
Additional Information
****
xx = slot number entered in Step 3
Next
Enter
Dial or type [ n ].
System Manager
Loop-Start: All; Ground-Start: Hybrid/PBX only
Not required
Form 2c, System Numbering: Line/Trunk Jacks
Touch-tone
= option name selected in Step 5
NOTE:
If you get the Trunk Busy message,
wait for an idle condition or exit
system programming and try again
later.
Return to Step 6. The next slot number
will be displayed on Line 1.
4
4
Issue 1
June 1997
Page 4-29
PC
Ã