Lucent Technologies MERLIN LEGEND Release 5.0 System Programming Manual page 473

MERLIN LEGEND Communications System Release 5.0
System Programming 555-650-111
4 Programming Procedures
Lines and Trunks
Factory Setting
Valid Entries
Inspect
Copy Option
Console Procedure To program a single line/trunk:
PC Procedure
Procedure: Trunks to Pools Assignment
Console Display/Instructions
Select the Lines and Trunks menu.

System Programming:
Make a selection
System
SysRenumber
Operator
LinesTrunks
Exit
Select Pools.

Lines and Trunks:
Make a selection
LS/GS/DS1
TIE Lines
TT/LS Disc
DID
Exit
All loop-start trunks are assigned to the main trunk pool
(factory-set extension number 70); all tie trunks are assigned
to the trunk pool with the factory-set extension
number 891; no factory-set extensions numbers are assigned
to ground-start trunks.
Line numbers
Yes
Yes
LinesTrunks
entry mode
line/trunk
To program a block of lines/trunks:
LinesTrunks
block of lines/trunks
On/Off
Enter
To program a single line/trunk:
of the line/trunk
To program a block of lines/trunks:
lines/trunks
Additional Information
>
Extensions
Options
Tables
AuxEquip
NightSrvce
>
PRI
Copy
RemoteAccss
Pools
_
Toll Type
Dial pool dial-out code
Pools
Dial no. of the
Enter Exit Exit
Dial pool dial-out code
Pools
Toggle LED
Exit Exit
Type pool dial-out code
Type pool dial-out code
Toggle letter R On/Off
4
Issue 1
June 1997
Page 4-66
Select
Select
Type no.
Select block of
PC