Lucent Technologies MERLIN LEGEND Release 5.0 System Programming Manual page 31

MERLIN LEGEND Communications System Release 5.0
System Programming 555-650-111
1 Programming Basics
Programming Procedures
The examples in the following text refer to Steps
Procedure (above), which is a branch of the Network Services procedure.
When you are to repeat a step within the branch procedure, you are instructed to
go to that step. For example, at Step 4 of the branch procedure you would go
back to Step 1 of the branch procedure and repeat branch Steps 1 through 4 for
additional toll services. If you did not need to enter any other toll services, you
would continue with Step 5 of the branch procedure.
When a branch step instructs you to return to the main procedure, the branch
procedure is complete. At Step 5 of the branch procedure you would return to
Step 4 of the Network Services procedure to continue. In some cases, you can
select
Exit
are noted in specific programming procedures. In cases where completing the
branch procedure also completes the main procedure you are instructed to select
(
Exit
menu.
Single or Block Items
Branching is also used when you can select between programming a single item
or a block of items, such as a single line or a block of lines, as shown in sample
Step 5.
Console/Display Instructions
Specify the line(s).

B-Channel Group xx :
Assign lines
Lines 01-20
Lines 21-40
Lines 41-60
Lines 61-80
Exit
Continue with this step when you complete the branch procedure.

l
Single Line Procedure
Specify entry mode.

Select
Entry Mode
And so on ...

Return to Step 6 of the main procedure.

( on the PC) to return to the menu where the branch begins; these
on the PC) one or more times to return to the system programming
Entry Mode
.
1 through
Additional Information
l u
xx = number entered in Step 2
To select a single line, go to
l
Single Line Procedure.
To select a block of lines, go to
u
Block of Lines Procedure.
Issue 1
June 1997
Page 1-17
l
5 of the AT&T Toll
PC
1