Lucent Technologies MERLIN LEGEND Release 5.0 System Programming Manual page 128

MERLIN LEGEND Communications System Release 5.0
System Programming 555-650-111
2 Programming with SPM
Using SPM
Select the target device for the reports.

Printer Options
Make a selection
SMDR Port
PC Port
Exit
Press to return to the SPM Main Menu.

SMDR Port Output
See ''Printing System Reports''
procedure using the system console and the SMDR port.
PC Port Output
See ''Printing Reports''
and the PC port.
Restore
The Restore option allows qualified service personnel to load system
programming from either a diskette or from the hard disk into the processor
module memory.
This procedure is used either to program a new system if a disk was created
through surrogate mode programming, or to restore information (using a backup
disk) lost through system failure. It is also part of the upgrade procedure.
Considerations
Review the following items before you begin the restore procedure.
The system will be forced idle during a restore procedure.
You must have a backup file containing system programming before you
use this procedure. See ''Backup''.
Features that were not programmed when the backup file was created are
reset to factory defaults.
The data restored reflects the number of extensions and lines available on
the system at the time the backup was created. The remaining extensions
and lines are set to the default values that are initialized during a Restart
(cold start).
in Chapter 3
for more information about the print procedure using SPM
2
for more information about the print
2
2
Issue 1
June 1997
Page 2-44
2