Inter-Digit; Area Code - Exchange - Lucent Technologies MERLIN LEGEND Release 5.0 System Programming Manual

MERLIN LEGEND Communications System Release 5.0
System Programming 555-650-111
3 Common Administrative Procedures
System Features
Inter-digit Timers
This procedure to program inter-digit timers has not yet been implemented. If
situations occur where a caller is attempting to make an outside call and becomes
connected to an incoming call, the caller may not be able to put the incoming call
on hold or transfer the call. Setting inter-digit timers to shorter times will permit the
call to be put on hold or transfered. If you are experiencing these types of
problems, call the Lucent Technologies Helpline at 1 800 628-2888.
Allowed Lists
Use this procedure to establish Allowed Lists. These lists are telephone numbers
that can be dialed from specified telephones, regardless of any calling restrictions
assigned to the telephones.
A maximum of eight lists (numbered 0 through 7), with a maximum of 10 numbers
each (numbered 0 through 9) allowed. Each allowed number can be no more than
six digits (an area code plus an exchange) or six digits with a leading 1, where
required.
If you program 0 as the first digit of a list entry, any toll restriction assigned to the
extension is removed for calls that can be placed by a toll operator.
Special characters (such as Pause) are not permitted in Allowed List entries.
Summary: Allowed Lists
Programmable by
Mode
Idle Condition
Planning Form
Factory Setting
Valid Entries
Inspect
Copy Option
Console Procedure
PC Procedure
System Manager
All
Not required
Form 6g, Call Restriction Assignments and Lists
Not applicable
Area code/exchange (1- to 6-digits with leading 1, if
necessary)
No
No
Tables AllowList
no. Drop
Enter
Type list no. and entry no.
+ Type no.
3
3
3
Dial list no. and entry
Dial no.
Enter Exit
Issue 1
June 1997
Page 3-197