Lucent Technologies MERLIN LEGEND Release 5.0 System Programming Manual page 676

MERLIN LEGEND Communications System Release 5.0
System Programming 555-650-111
4 Programming Procedures
Optional Group Features
Group Calling Delay Announcements
Use this procedure to designate the announcement devices used to play
messages to callers while they are waiting in the queue.
Two announcement devices can be designated for each calling group; however,
more than one calling group can use the same announcement device. The
extensions to which the delay announcement devices are connected should not
be programmed as a calling group member.
If the extension jack or MFM was previously programmed as a regular extension,
you must remove all line/trunk button assignments before you designate the
extension jack as a delay announcement device.
Summary: Group Calling Delay Announcement
Programmable by
Mode
Idle Condition
Planning Form
Factory Setting
Valid Entries
Inspect
Copy Option
Console Procedure
PC Procedure
Group Coverage Receiver
Use this procedure to assign or remove a calling group as a receiver for a
coverage group.
Calling group member assignments must be made before you assign the group as
a receiver for a coverage group.
NOTE: NOTE: NOTE:
Integrated Administration uses calling group 30 as the default group to
cover AUDIX Voice Power.
System Manager
All
Not required
Form 7d, Group Calling
No delay announcement devices are assigned
Primary Announcement, Secondary Announcement
No
No
More
Extensions
calling group ext. no.
Secondary Announcement
Announcent device
no. or
device
4
4
Grp Calling DelayAnnce
Enter Primary Announcement
Enter Exstenion number of
Enter Exit Exit
Type calling group ext.
Type ext. no. of announcement
4
Issue 1
June 1997
Page 4-269
Dial
or
Exit