Lucent Technologies MERLIN LEGEND Release 5.0 System Programming Manual page 460

MERLIN LEGEND Communications System Release 5.0
System Programming 555-650-111
4 Programming Procedures
Lines and Trunks
3. If a trunk assigned to ring into the QCC queue is also used for shared
4. Do not change the factory setting of No QCC Operator Assigned to
Summary: QCC Operator to Receive Calls
Programmable by
Mode
Idle Condition
Planning Form
Factory Setting
Valid Entries
Inspect
Copy Option
Console Procedure To program a single line/trunk:
PC Procedure
remote access, see "Remote Access Trunk Assignment." You must
assign remote access before you assign a QCC system operator to
receive calls (see ''QCC Operator to Receive
Receive Calls for trunks dedicated to incoming calls for calling groups,
trunks used as personal lines, DID trunks, unequipped DS1 trunks, or
dial-in tie trunks.
System Manager
Hybrid/PBX
Not required
Form 2c, System Numbering: Line/Trunk Jacks
No QCC operator is assigned to receive calls.
Extension number of first or fifth extension jack
Yes
No
LinesTrunks
no.
Enter
no.
Enter
To program a block of lines/trunks:
LinesTrunks
no.
Enter
On/Off
Enter
To program a single line/trunk:
line/trunk no.
To program a block of lines/trunks:
lines/trunks
4
More
QCC Oper
Select entry mode
Enter Enter
More
QCC Oper
Select block of lines/trunks
Exit Exit
Type ext. no.
Type ext. no.
Toggle letter On/Off
G
Issue 1
June 1997
Page 4-53
Calls'').
Dial ext.
Dial line/trunk
Dial ext.
Toggle LED
Type
Select block of