Lucent Technologies MERLIN LEGEND Release 5.0 System Programming Manual page 428

MERLIN LEGEND Communications System Release 5.0
System Programming 555-650-111
4 Programming Procedures
System Renumbering
PC Procedure
Direct Station Selector (DSS) Page Buttons
Use this procedure to set the three Page buttons on the DSS to correspond to the
system numbering plan. This procedure assigns extension numbers to DSS
buttons. You cannot program individual buttons on a DSS; this is the only method
for programming DSS buttons.
Page button assignment should be sequential. If only one DSS is attached, each
Page button assignment sets the console for a range of 50 extension numbers:
Page 1: 0 to 49; Page 2: 50 to 99; Page 3: 100 to 149.
If two DSSs are attached, each Page button assignment sets the console for a
range of 100 extension numbers. If two DSSs are attached to the console, change
the factory setting so that the difference between extension numbers assigned to
the range is at least 100. For example, assign Page 1 to begin with extension 10,
Page 2 to begin with extension 110, and Page 3 to begin with extension 210.
Operator Park Zone codes must be included in the extension number range
specified for one of the Page buttons.
!
Summary: Assign Direct Station Selector Page
Buttons
Programmable by
Mode
Idle Condition
Planning Form
Factory Setting
Valid Entries
Inspect
Copy Option
Console Procedure
member
member
no.
CAUTION:
Select on the console or
Exit
this procedure. If you press Home, extensions may remain in the
forced idle condition (the LED next to each DSS button is on), and the
system may have to be restarted.
System Manager
All
Not required
Form 6a, Optional Operator Features
Page 1=0; Page 2=50; Page 3=100
1, 2, 3
Yes
No
SysRenumber
no.
Enter
Select type of group
Type no. of last group
Type new beginning
4
on the PC when you have finished
4
More
Single
Dial first ext. no.
June 1997
Page 4-21
Type no. of first group
Dial page
DSS Buttons
Enter Exit Exit
Issue 1