Dial Mode - Lucent Technologies MERLIN LEGEND Release 5.0 System Programming Manual

MERLIN LEGEND Communications System Release 5.0
System Programming 555-650-111
4 Programming Procedures
Tie Trunks
Console Display/Instructions
Specify the type of signaling for the trunk.

Trunk xxx :
Select E&M Trk Signaling
Type1S
Type1C
Type5
Exit
Continue to assign E&M signaling to another trunk or go to Step 8.

Select .
Next
Save your entry.

Select .
Enter
Return to the System Programming menu.

Select twice.
Exit

Dial Mode

Use this procedure to specify whether an incoming or outgoing tie trunk is
touch-tone or rotary.
Touch-tone cannot be programmed for incoming immediate signaling tie trunks.
Users of touch-tone single-line telephone cannot make calls by using individual
trunks programmed for rotary operation. The touch-tone signals generated from
the telephone while the user is dialing are transmitted to the central office at the
same time the rotary signals are sent to the system. The central office receives
both signals and cannot process the call.
Summary: Dial Mode
Programmable by
Mode
Idle Condition
Planning Form
Factory Setting
Valid Entries
Additional Information
xxx = trunk entered in Step 4
Select
Next
Type1C
Enter
Type5
System Manager
All
Not required
Form 3c, Incoming Trunks: Tie
Rotary
Rotary, Touch-tone
,
Type1S
, or
.
Return to Step 6. The next trunk will be
displayed on Line 1.
4
4
Issue 1
June 1997
Page 4-112
PC