System Renumbering - Lucent Technologies MERLIN LEGEND Release 5.0 System Programming Manual

MERLIN LEGEND Communications System Release 5.0
System Programming 555-650-111
4 Programming Procedures

System Renumbering

Set System Time
The System Time feature allows you to set the time that appears on MLX display
telephones and on SMDR reports. See
Procedures''
Summary: Set System Time
Programmable by
Mode
Idle Condition
Planning Form
Factory Setting
Valid Entries
Inspect
Copy Option
Console Procedure
PC Procedure
System Renumbering
The procedures in this section are used to assign the two-digit, three-digit, and
Set Up Space numbering plans.
NOTE: NOTE: NOTE:
System Renumbering is called Flexible Numbering in the MERLIN II
Communications System. This is not the same as Board Renumbering, an
option used when modules in the control unit are changed.
Do not attempt to assign a numbering plan without Planning Forms 2a, System
Numbering: Extension Jacks; 2b, System Numbering: Digital Adjuncts; and 2d,
System Numbering: Special Renumbers. Form 6a, Optional Operator Features, is
needed to assign a DSS Page button.
This section contains the following programming procedures:
Select System Numbering Plan
Direct Station Selector (DSS) Page Button Assignment
This section contains summaries of the following procedures which are described
in detail in
Single 4Renumbering
Block Renumbering
for detailed information.
System Manager
All
Not Required
Form 1, System Planning
0000
0000 to 2359
No
No
System Time
Chapter 3, ''Common Administrative
4
Chapter 3, ''Common Administrative
4
Drop Dial current time
+ Type current time
4
Procedures'':
Issue 1
June 1997
Page 4-13
Enter Exit