Lucent Technologies MERLIN LEGEND Release 5.0 System Programming Manual page 24

MERLIN LEGEND Communications System Release 5.0
System Programming 555-650-111
1 Programming Basics
Programming Procedures
Procedure Contents
Each procedure begins with a general description of the feature, followed by a
summary of programming information that includes the items listed below.
Programmable by
Mode
Idle condition
Planning form
Factory setting
Valid entries
Inspect
Copy option
Console Procedure
PC Procedure
This list is followed by the step-by-step programming procedure for the feature.
See ''Using the Programming Procedures''
use the programming procedures.
Programming Screens
There are three types of system programming screens:
Information screens, to view what is currently programmed on the system.
Menu selection screens, to select options from a menu.
Data entry screens, to enter values or to identify a specific extension or
line/trunk you want to program.
Figure 1-5
from the main menu screen (shown in
Figure 1-5
Indicates who has permission to use the procedure.
Specifies which system mode supports the procedure: Key,
Hybrid/PBX, Behind Switch, or a combination.
Specifies the idle state required before the procedure can
be performed.
Indicates the planning forms that provide information for the
procedure.
Shows the default settings, if any, for equipment or features
affected by the procedure.
Specifies the characters, numbers, or values accepted
during data entry.
Specifies whether or not the feature status can be verified
using the Inspect feature.
Indicates whether or not the feature programmed with the
procedure can be copied to another system component.
Provides a summary of the procedure steps using the
system console.
Provides a summary of the procedure steps using SPM.
shows a sample information screen. When you select
appears with system setup information
1
for complete information about how to
1
Figure 1-2), the screen shown in
Issue 1
June 1997
Page 1-10
Sys Program