Lucent Technologies MERLIN LEGEND Release 5.0 System Programming Manual page 88

MERLIN LEGEND Communications System Release 5.0
System Programming 555-650-111
2 Programming with SPM
Installing the SPM Software
The installation program automatically performs the following:
Checks available space on the hard disk. If space is insufficient, the
installation is terminated and an error message is generated.
Checks the autoexec.bat and config.sys files. If either file is
write-protected, the installation is terminated and an error message is
generated. SPM must make changes to these files.
Saves a copy of autoexec.bat as autoexec.old.
Saves a copy of config.sys as config.old.
If autoexec.bat has not already been configured for SPM, performs the
following:
Adds the following line to config.sys if it is not already present
DEVICE=C:\ANSI.SYS
Copies the ansi.sys file from the floppy disk to c:\.
Creates the directory c:\spm.
Copies the following files from the floppy disk into c:\spm:
Creates the following directories if they do not already exist:
Does one of the following:
Follow the steps below to install SPM on the PC's hard disk.
Switch to Drive A, if it is not already the current drive.

— Adds to the path statement
c:\spm
— Adds the line
SET AMS_PATH=C:
— Adds the background print command
PRINT /D:PRN /B:4096 /U:3 /M:200 /S:1 >NUL
.
— spm.exe
— ams_hlp.eng (English language help file)
— ams_hlp.fre (French language help file)
— ams_hlp.spa (Spanish language help file)
— c:\spm\backup
— c:\spm\reports
— c:\spm\tmp
— Creates the SPM configuration file c:\spm\ams.cfg, if it does not
already exist. In this case, the ams.cfg file consists of only one line,
in which the language attribute is specified:
English or did not specify a language with the
— Modifies the ams.cfg file, if it already exists, by adding or changing
the LANG value.
Issue 1
June 1997
Page 2-4
if you specified
LANG 1
command;
install