Lucent Technologies MERLIN LEGEND Release 5.0 System Programming Manual page 560

MERLIN LEGEND Communications System Release 5.0
System Programming 555-650-111
4 Programming Procedures
PRI Facilities
Console Display/Instructions
Return to the System Programming menu.

Select three times.
Exit
Block Procedure
Specify the block of 20 lines associated with 20 buttons on the system program-

ming console.
Select
Lines 01-20
Lines 21-40
Lines 41-60
Lines 61-80
Assign the line(s) to the B-channel group.

Return to the System Programming menu.

three times.
Select
Exit
Network Service
Use this procedure to specify the type of outgoing service provided by each
B-channel group [Megacom WATS and 800, MultiQuest Service, ACCUNET
Switched Digital Service (SDS), or Software Defined Network (SDN)].
NOTE: NOTE: NOTE:
You can enter a service not shown on the Network Service screen by using
the five-digit binary code that represents the service in the Network
Facilities Information Element of ISDN PRI signaling protocol. For
information on these codes, contact your service provider. See
"Miscellaneous Procedure."
Summary: Network Service
Programmable by
Mode
Idle Condition
Planning Form
Factory Setting
Additional Information
Toggle the green LED on or
off as required.
On = lines are assigned to B-channel
Off = lines are not assigned to B-channel
System Manager
Hybrid/PBX, Key
Not required
Form 3b, Incoming Trunks: DS1 Connectivity
(100D module)
Not applicable
4
4
Issue 1
June 1997
Page 4-153
PC