Lucent Technologies MERLIN LEGEND Release 5.0 System Programming Manual page 640

MERLIN LEGEND Communications System Release 5.0
System Programming 555-650-111
4 Programming Procedures
Telephones
Console Display/Instructions
Select Maintenance Alarms.

Auxiliary Equipment:
Make a selection
MusicOnHold
Ldspkr Pg
Fax
MaintAlarms
Exit
Enter the line/trunk jack to which the maintenance alarm is connected.

Maintenance Alarms:
Enter maintenance alarm
line number
Backspace
Exit
Assign or remove the line/trunk.

Select
Enter
Delete
Return to the System Programming menu.

Select twice.
Exit
Voice Messaging System and Automated
Attendant
Use this procedure to specify the touch-tone duration and the interval between
digits in codes sent between a voice messaging system and the communications
system. The touch-tone duration and interval between digit assignment must be
the same as those programmed on the voice messaging system.
This procedure specifies the integrated voice messaging ports (line/trunk jacks)
used to connect voice messaging systems such as MERLIN MAIL Voice
Messaging System or the AUDIX Voice Power-Integrated Solution II/III
application. It also specifies the generic VMI ports (line/trunk jacks) used for
automated attendants, such as Integrated Voice Power Automated Attendant IS
II/III.
In addition, this procedure can be used to specify the number of rings before a call
transferred by the voice messaging system is sent to the backup position for both
integrated and generic VMI ports. The number of rings cannot be programmed for
individual voice messaging systems; the single setting applies for all. Use the
VMS/AA
CTI Link
Delete
Enter
or
.
Additional Information
Dial or type:
Trunk number [ ]
nnn
Slot and port number
Logical ID number
#
4
Page 4-233
[ sspp ]
*
[ nnn ]
Issue 1
June 1997
PC
Ã